Pioneer AVIC-X3-II - Manual (Page 25)

Reset the navigation system to
the initial (factory) setting
When you want to erase memorised settings
and return the navigation system to its initial
(factory) settings, carry out the following op-
erations.
1 Turn the engine ON or set the ignition
switch to ACC position.
2 Press RESET button with a pen tip or
other pointed instrument.
p Some navigation settings and data are not
erased.
DVD Map Discs for Your
Navigation System
Configuration of data recorded
on discs
The map for this navigation system is supplied
on three discs; for the west, for the central,
and for the east. Please set the disc to use ac-
cording to your destination or current location.
The areas recorded on each disc are as fol-
lows:
West area disc East area disc
Central area disc
p Removing the disc and inserting other disc
causes the navigation system to automati-
cally restart and reload the new route. (This
automatic
“Reroute” operation cannot be
cancelled.)
Initial Use
If the initial learning is not complete, following
screen appears.
% If a message appears, touch [OK].
When the navigation system begins running
for the first time, the 3D Hybrid Sensor auto-
matically begins initial learning. Positioning is
performed solely by GPS satellites until the 3D
Hybrid Sensor initial learning is complete, so
the location of your vehicle may not be very ac-
curate. This is not an error. When the initial
learning is complete, the location of your vehi-
cle can be detected with high accuracy.
p [Shop Demo] is the demonstration used in
a store. Do not touch [ Shop Demo].
= If an error message appears during initial
learning, refer to Messages and how to
react to them on page 135.
Introduction
Engb
25
Chapter
01
Intr
oduction