Bay Technical Associates BayStack ARN Routers none - Manual (Page 105)

Using Local Boot (the Quick-Start Procedure)
114200 Rev. A B-3
Filling Out the Worksheets
The inst_arn.bat script provides many options for configuring the ARN on a
network. Since typical remote access uses a serial interface over a wide area
connection, this section lists only the options involved with a serial configuration.
We suggest the following procedure when you fill out worksheets:
1. Fill out the Global Information Worksheet completely.
This worksheet lists options common to all serial interface configurations.
2. After you record your protocol selections on the Global Information
Worksheet, fill out one Router Protocol worksheet.
This worksheet lists specific options for RIP, OSPF, or Static Route
configurations. For example, if you select RIP as your routing protocol, you
need to fill out only the worksheet pertaining to RIP.
3. Fill out one Wide Area Protocol worksheet.
This worksheet lists specific options for Bay Networks (proprietary)
Point-to-Point Protocol (PPP), Frame Relay, Standard PPP, and switched
multimegabit data service (SMDS) configurations. For example, if you select
Frame Relay as your wide area protocol, you need to fill out only the Frame
Relay worksheet.
4. Run inst_arn.bat as described in “ Running the Quick-Start Script ” later
in this chapter.
Or, a remote-site operator runs the installation script as described in the
hardware installation guide.
5. Once the router has an initial connection to the network, use the guide
Configuring Routers to configure the router using Site Manager.
Note: This section provides worksheets only for a serial interface
configuration over a wide area connection. It does not contain worksheets for
LAN configuration options.