Bay Technical Associates BayStack ARN Routers none - Manual (Page 89)

Operating the ARN
114200 Rev. A 3-11
Resetting the ARN
The Reset button is set inside the ARN back panel and resides next to the Flash
card slot, as shown in Figure 3-3.
Figure 3-3. ARN Reset Button
To press the Reset button, insert a small pointed object (for example, a paper clip)
into the Reset button hole.
Yo u can use the Reset button to reboot the ARN hardware without cycling power,
as follows:
• To warm-boot the ARN (no diagnostic tests run), press the Reset button for
less than 5 seconds.
• To cold-boot the ARN (diagnostic tests run), press the Reset button for more
than 5 seconds.
Note: If you reset the ARN while it is running its diagnostic tests, the LEDs
remain in the state they were in when you pressed the Reset button. You must
cycle power on the ARN to reset the LEDs.
ARN0052A
Reset button
Console Modem
Redundant Power
UL
UL
100-240~
1.2A
50-60Hz