Bay Technical Associates BayStack ARN Routers none - Manual (Page 35)

Installing the BayStack Advanced Remote Node
114200 Rev. A 1-5
Verifying Site Requirements
The installation site must provide a certain amount of free space around the ARN
to dissipate heat, as detailed in
Table 1-1 .
In addition, the installation site must meet the electrical and environmental
specifications listed in Appendix C.
Installing the ARN
Once you are ready to install the ARN in its final location, you can
• Position the ARN on a flat, sturdy, horizontal surface.
• Mount the ARN in an electronic enclosure rack.
Positioning the ARN on a Flat Surface
When positioning the ARN on a flat surface, make sure that the surface is
• Large enough for the ARN to operate properly
• Sturdy enough to support the combined weight of the ARN and any cables
that you connect
We recommend that you place the self-adhesive, rubber feet on the bottom of the
ARN chassis (shipped with the ARN). These feet not only protect the surface on
which you position the ARN, they provide added friction against the weight of
any cables that you attach to the device.
Table 1-1. Installation Space Requirements
Width Depth (minimum) Depth (for servicing)
22.5 in. (57.2 cm) 15 in. (38.1 cm) 25 in. (63.5 cm)
Caution: You must use grounded electrical power outlets with the ARN.