Bay Technical Associates BayStack ARN Routers none - Manual (Page 58)

Installing and Operating BayStack ARN Routers
1-28 114200 Rev. A
Installing the Flash Memory Card
A PCMCIA Flash memory card (Figure 1-19) provides storage capability for the
Nonvolatile File System (NVFS) in the ARN. When you remove a formatted
memory card, the NVFS automatically removes access to the card. When you
insert and format a card or insert an already formatted card, the NVFS
automatically provides access.
Figure 1-19. Flash Memory Card
Before starting the ARN, install the Flash memory card supplied with the router
by following these steps:
1. Position the card with the label facing up and the INSERT arrow
pointing toward the card receptacle.
2. Insert the card into the receptacle.
Figure 1-20 shows how to insert the Flash memory card in an ARN.
3. Gently push the card until it fits snugly into place.
If the card is new, and you did not obtain it from Bay Networks, you must format
the card before attempting to write to it. You can format the card using Site
Manager software or the
format command available with the Bay Networks
Technician Interface. (Refer to Using Technician Interface Software for
instructions.)
INSERT
AN0060A