Bay Technical Associates BayStack ARN Routers none - Manual (Page 155)

Index
114200 Rev. A Index-7
power
cables, 1-27
specifications, C-2
switch, 3-10
Power (Pwr) LED, 3-3
powering on the ARN, 3-10
PPP protocol, Bay networks proprietary, B-11
PPP wide area protocol, worksheet for, B-13
preparing for installation, 1-2 to 1-8
Q
Quick-Start procedure
commands, B-16
inst_arn.bat script, 2-16
running, 2-16, B-15
using, 2-16, B-16
worksheet, B-4 to B-7
R
rack-mounting
procedure for, 1-6 to 1-8
required hardware, 1-6
receive (RX) LED, 3-8
receive (Rx) LED, 3-4, 3-5
receive data (RxD) LED, 3-7
received line signal detection (RLSD) LED, 3-6,
3-8
received line signal detection 3 (RLSD3) LED,
3-6
received line signal detection 4 (RLSD4) LED,
3-6
received line signal detection 5 (RLSD5) LED,
3-6
receiver (RCVR) LED, 3-4, 3-5
redundant power supply (RPS) LED, 3-3
reset button
LEDs and, 3-11
using, 3-11
RIP routing protocol, worksheet for, B-7
RJ-11 interface pin assignments, C-13
RMON (remote monitoring), 3-3
router software image
default boot location, 2-4
defined, 2-1
RS-232 connections
console (service) interface, C-13
serial interface, C-8
service modem interface, C-14
RS-422 connections, C-8
RS-530 connections, C-8
rubber feet, using, 1-5
Run LED, 3-3
S
serial
cables, connecting, 1-15
interfaces
adapter module, 1-10
adapter module LED, 3-6
base module LEDs, 3-6
configuring, A-2
connecting to, 1-15
expansion module, 1-9
expansion module LEDs, 3-6
ifconfig settings, A-2
pin assignments, C-9
specifications, C-8
shipment contents, verifying, 1-2
site requirements, 1-5, C-1
SMDS wide area protocol, worksheet for, B-15
software image
default boot location, 2-4
defined, 2-1
specifying location of, A-7
space requirements, C-1
specifications
electrical, C-2
environmental, C-2