Figure 2-2, Verifying directed netboot configuration -13 – Bay Technical Associates BayStack ARN Routers none User Manual
Page 73
Starting the ARN
114200 Rev. A
2-13
3.
Type the following command and press the Return key to verify the
configuration you specified in Step 3:
getcfg
The
getcfg
command shows the location of the boot image and the network
configuration file, the interface configuration that you specified using the
ifconfig
command, as well as the TFTP server information and file paths that
you specified using the
bconfig
commands.
Verify the interface configuration, as shown in
.
Figure 2-2.
Verifying Directed Netboot Configuration
If
getcfg
displays the correct information, continue to Step 4. Otherwise,
reenter the correct
ifconfig
and
bconfig
commands. Contact your network
administrator if you need assistance.
4.
Type the following command and press the Return key to boot the ARN:
boot
ARN0080A
$ getcfg
Boot Options
boot image = network
boot config = network
host IP address = 192.32.5.8
image pathname =
"/usr/arnstartup/krnl_arn.exe"
config pathname =
"/usr/arnstartup/config"
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install (disabled)
COM3...EZ-Install (disabled)
COM4...EZ-Install (disabled)
COM5...EZ-Install (disabled)