Bay Technical Associates BayStack ARN Routers none - Manual (Page 116)

Installing and Operating BayStack ARN Routers
B-14 114200 Rev. A
Enable use of the Remote Peer
router’s LQR Timer? (y/n) [y]:
(For LQR Protocol only)
y(es)
n(o)
Note: If the LQR timer is
enabled, the remote peer router
maintains its own LQR timer for
this interface. When the LQR
timer is disabled, the AN is
responsible for maintaining the
timer for this interface.
Number of seconds (1-120) [3]:
(For LQR Protocol only)
Enter the maximum number of
seconds between the
transmission of LQR packets.
Enter [inbound] success rate
percentage (1-100) [90]: Enter the minimal acceptable
success rate (percentage) of
packets transmitted by the peer
router and received on this
interface over the last five LQR
reporting periods.
Enter [outbound] success rate
percentage (1-100) [90]: Enter the minimal acceptable
success rate (percentage) of
packets transmitted by this
interface and received by the
peer router over the last five LQR
reporting periods.
PPP Standard Worksheet (continued)
Requested Information Options Your Response