Bay Technical Associates BayStack ARN Routers none - Manual (Page 43)

Installing the BayStack Advanced Remote Node
114200 Rev. A 1-13
Connecting to a Token Ring Interface
You can connect a token ring cable to any ARN base module or expansion module
that contains a token ring interface option. Each of these interface options offers
two token ring interface types -- an STP interface or a UTP interface.
Connecting to an STP Token Ring Interface
To connect a token ring STP cable to the base module or expansion module token
ring interface:
1. Attach the 9-pin D-SUB plug to the token ring STP interface ( Figure 1-7 ).
Figure 1-7. Connecting a Token Ring STP Cable
2. Secure the token ring cable using the capture screws.
Note: You can use only one token ring interface on an ARN base or expansion
module at any time. For example, you can connect to either the STP interface
or the UTP interface on a base module, but you cannot use both interfaces at
the same time.
ARN0068A
COM3 COM4 COM5
COM
U
D
DD
B1
B2
RLSD Run
Boot
Fail
Pwr
RPS
Fan
Base
Adapter1
Adapter2
Expansion
DCM
PCMCIA
BayStack Advanced Remote Node
RLSD3
RLSD4
RLSD5
1
2
Serial
Serial
ISDN BRI
withNT1
STP
RCVR
NSRT
WFLT
Token Ring 1
To
Token Ring
network
Token Ring STP cables
STP RCVR
NSRT
WFLT
Token Ring 2
Expansion module STP interface
Base module STP interface
UTP