Bay Technical Associates BayStack ARN Routers none - Manual (Page 111)

Using Local Boot (the Quick-Start Procedure)
114200 Rev. A B-9
Enter OSPF interface type selection
[1]: 1. Broadcast
2. NBMA
3. Point-to-Point
4. Point-to-Multipoint (Proprietary)
5. Point-to-Multipoint (Per OSPF
Standard)
Note: When using a wide area
protocol other than Bay Networks
Proprietary PPP, we suggest
selecting NBMA.
Enter decimal value in seconds for
Hello Interval [10]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast -- 10 seconds
Point-to-Point -- 15 seconds
NBMA -- 20 seconds
Point-to-MultiPoint --10 seconds
Enter decimal value in seconds for
Router Dead Interval [40]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast -- 40 seconds
Point-to-Point -- 60 seconds
NBMA -- 80 seconds
Point-to-MultiPoint (STD) -- 40
seconds
Enter decimal value for Router Priority
[1]:
(For Broadcast, NBMA, or
Point-to-MultiPoint)
Enter a router priority value. The
lower the value (above zero), the
higher the priority.
Note: If you set the router priority
to zero (0), the router is not eligible
to become the designated router
on this network.
(continued)
OSPF Worksheet (continued)
Requested Information Options Your Response