Black Box LRA005A-R2 - Manual (Page 147)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
147
domain listservers
domain query host_addr
domain retry [count]
domain suffix [domain_suffix]
domain cache list
Configure/display the Internet Domain Name
domain cache size [count] Service
filter add name { [-s {[src_addr/bits] [src_port]} ]
[-d {[dest_addr/bits] [dest_port]} ]
[-p proto ]
[-l [{syslog | trap | both}] ]
[-i iface]
[-f {inbound | outbound}] }
-t {allow | deny | nodial | unreach}
[-o {before | after} existing_name]
filter delete name
filter {enable | disable}
filter flush
filter move name [{before | after} existing_name]
filter spoof iface [{enable | disable}] [syslog] [trap]
filter status
filter try src_addr [-s port] dest_addr [-d port ] [-p proto]
Configure/display IP filter information
icmp status Display ICMP protocol status
ifconfig [iface [address addr [/bits] ]
[broadcast addr]
[metric [hops]]
[mtu size] ]
[netmask mask]
[peer addr[/bits]]
[ rip [{active | passive | off}] ]
[ speed [bps] ]
[{up | down}]
Configure network interface parameters
ifconfig [iface [linkaddr directory_number [/SPID ] ] ] Configure interface to assign ISDN
address and distinguish between
multipoint and point-to-point
connection via SPID assignment
ip address [host_addr]
ip routing [{enable | disable}]
ip rtimer [seconds]
ip status
ip ttl [hops]
Configure/display IP protocol information
ipx [ipx_command param ...] Change to IPX mode
netstat [-a] [-s] [-r] [-m] Show protocol and memory statistics
ping dest_addr
ping dest_addr [packet_size]
ping -s dest_addr [packet_size] [count]
Send ICMP ECHO_REQUEST packets to network nodes (to
see if the remote node is up and running)
rip accept router_addr