Black Box LRA005A-R2 - Manual (Page 153)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
153
ifconfig modem0 netmask 255.255.255.0 peer 0.0.0.0 mtu 1500
dialup modem0 demand 555-5555 240
dialup modem0 volume low
domain suffix rns.com
domain addserver 0.0.0.0
ppp modem0 lcp local auth chap
route add 0.0.0.0/0 modem0 0.0.0.0
route add default eth0
snmp set location “Computer Room”
snmp set contact “BBC Technical Support”
snmp set community public
start discard
start echo
start ftp
start telnet
start snmp
ifconfig console up
ifconfig eth0 up
ifconfig modem0 up
ipx
ipx routing enable
ifconfig eth0/802.3 network 00000001 up
ifconfig eth0/II network 00000002 up
ifconfig eth0/802.2 network 00000003 up
ifconfig eth0/SNAP network 00000004 up
ifconfig modem0 up
tcp/ip
The following table is generated by the previous CONFIG.NET file:
(tcp/ip)Router> route
Destination Bits Interface Router/Next Hop Metric Timer Use
Flags
0.0.0.0 /0 modem0 0.0.0.0 1 0 0
0.0.0.0 /0 eth0 0 0 0
default /0 eth0 1 0 0
3 Route entries
1.7.4 A BOUT IP A DDRESSES
Throughout many of the Router’s command descriptions, both Internet and Ethernet addresses are
specified as command parameters. IP addresses are specified in 4-byte Internet dotted-quad notation
(xxx.xxx.xxx.xxx), such as 128.66.16.100. When specifying subnet bits for an IP address, a /bits
parameter may be appended to the IP address. Only contiguous bits are supported for a Router subnet
mask. If no bit number is specified, 32 bits are assumed as default. Ethernet addresses are specified in
standard 6-byte Ethernet notation (xx:xx:xx:xx:xx:xx), such as 02:CF:1F:80:02:AB.