Black Box LRA005A-R2 - Manual (Page 241)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
241
means that the period of network inactivity has exceeded the idle timer setting in the dialup command.
Priority: LOG_INFO.
iface link stalled, hanging up
A modem link in keepup mode is idle and an attempted connection did not get a response. Try again
later. If problem persists, recycle the power. Priority: LOG_INFO.
iface misconfigured speed, actual_speed speed_tried
An attempt was made to set the serial port to an illegal speed. Correct the error in the dialup command
line and reissue the dialup command to the modem. Priority: LOG_ERR.
iface not initialized, dialer exiting
The modem was not initialized. If using a dialer script, verify that the initialization string is correct and
the command line is in the correct order. Otherwise, cycle the Router power off then on again to try
another modem initialization. If the modem still does not initialize, contact Technical Support. Priority:
LOG_ERR.
iface not ready
The Router has not received the DTR signal and the modem is not functional for unknown reasons.
Cycle the power off and on again. If the problem persists, call Technical Support for assistance. Priority
LOG_WARNING.
iface outdial not allowed
An attempt has been made to dial out from the Router while the interface has been configured for
incoming calls only. Priority: LOG_ERR.
iface redial failed m_response This should say OK
An attempt to redial and establish a modem connection failed with an unexpected modem response
message. The response that is displayed should have been the normal modem OK response. This error
will stop the Router from completing its current function, whether it is dialing from a script, or just re-
initializing the modem. Look for a dialer script error, then cycle the Router power from off to on to
restart the Router. Priority: LOG_ERR.
iface time connected: time Pkts sent: num Bytes sent: num Pkts recvd: num Bytes rcvd:
num
Normal usage statistics that are displayed at the end of every session. Priority: LOG_INFO.
iface tip or dialer already active
The interface is currently being used by tip or another dialer. Wait until the interface is not busy or
correct the busy condition. Priority: LOG_ERR.
iface total connections: xxx in: xxx out: xxx
At midnight each day the Router prints a connection report containing status information for total
connections, connections in, and connections out. Priority: LOG_INFO.
iface V.25bis call failed - reason_returned
A dialup connection using the V.25 bis protocol failed. The reason for failure is displayed with this