Black Box LRA005A-R2 - Manual (Page 244)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
244
A.1.8 SNMP GROUP
SNMP Trap addr unreachable trap type type_no
An attempt was made to send an SNMP trap with type type_no to an IP destination that is unreachable.
Reconfigure the SNMP access control group to specify a reachable IP address. Priority: LOG_ERR.
A.1.9 S YSTEM G ROUP
Restart complete version_string
Informational message that is displayed at the completion of a startup or reboot. Priority:
LOG_NOTICE.
SYSTEM: too many entries in the passwd file (max = 10)
The Router has detected the maximum entries in the passwd file. The current maximum is 10. Delete
any unused password entries, to add another. Priority: LOG_WARNING.
A.2 Console Messages
This section contains a listing of error and information messages, that are displayed either on the serial
port console attached to the Router, or on a remote console (in use during a Telnet session with the
Router).
If no local or remote console is in use, these messages will not appear.
Certain messages are prefixed with a capitalized name and a colon. This prefix is the name of the
Router software module that originated the message. When calling Technical Support about a message,
mention this module’s name. The prefix names are listed in alphabetical order with their associated
messages.
A.2.1 ARP G ROUP
ARP: iface Attach device first
While processing an arp command, the Router has determined that the Ethernet interface is not
working, or is not configured. Run the ifconfig command to determine the state of the Ethernet
interface. Re-issue the ifconfig command to mark the interface up, if necessary.
ARP: Unknown host : host_name
An attempt to enter a host name failed because the Router was unable to resolve the host_name to an IP
address. Check for typos on your command line.
A.2.2 DIALER G ROUP
DIALER: dialup once : iface already connected
A dialup once command was executed to dial on the modem. However, the dialer detected that the
modem was already connected. Use dialup reset to send a hangup command to the modem; then try
again.
DIALER: dialup once : iface is busy
The dialup once command can be used to verify a dialer script file or to verify a valid telephone line.
This message normally means that the phone on the other end is busy. Try again later or investigate the
reason for a busy phone. Use the dialup reset command if the modem at the other end of the phone line