Black Box LRA005A-R2 - Manual (Page 187)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
187
3. IPX-only commands
The Router is always in one of two modes. The prompt always indicates the current mode:
• (ipx)Router> Router is in IPX mode
• (tcp/ip)Router> Router is in TCP/IP mode
The commands in this chapter are for IPX mode only, supporting IPX network environments.
Commands which operate the same way in both IPX and TCP/IP environments are documented in
Chapter 2, Generic Commands. Commands for TCP/IP mode only are documented in Chapter 4,
TCP/IP-only Commands. Several commands operate in both IPX and TCP/IP modes with parameters
that vary per mode. These commands are documented with their appropriate parameters in both
chapters.
From IPX mode, either use the tcp/ip command to enter TCP/IP mode or prefix the command with
“TCPIP.”
IPX-only commands are organized in this chapter alphabetically:
• filter -filter ipx packets
• ifconfig -display or change IPX network parameters
• ipx -display or change IPX protocol parameters
• netstat -display IPX network statistics