Black Box LRA005A-R2 - Manual (Page 240)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
240
An abnormal condition has caused the modem to hang up. The modem result code is displayed at the
end of the message. Priority: LOG_ERR.
iface hangup failed
The Router attempted to hang up the phone but the modem did not respond as expected. As a result,
the Router will attempt to re-initialize the modem. Wait to see if re-initialization is successful before
taking any action. If not successful, reboot the Router. Priority: LOG_ERR.
iface hangup re-initialization failed
The Router has unsuccessfully attempted to re-initialize the interface. Try cycling power off then on
again, to reboot the Router. This could be a modem failure. Priority: LOG_ERR
iface hangup took: xxx milliseconds
If the modem hangup took an unusually long time, this message is displayed along with the hangup
time. Priority: LOG_NOTICE.
iface high usage, exceeded today’s quota of num minutes
You can set a quota limit for the amount of telephone online time allowed each day. (See Appendix B
in the User’s Guide at the front of this manual.) This message means that line use has exceeded the
established daily limit. You can wait until the next day when the daily quota is reinstated to make calls, or
request an increase in the daily quota from your network administrator. Priority: LOG_WARNING.
iface incoming call
The Router has sensed an incoming call and has answered the phone. Priority: LOG_NOTICE
iface is busy
The modem was already busy when an attempt was made to dial up a connection. Investigate and
correct the cause of the modem being already busy; then retry. If necessary, cycle the Router power off
then on again. Priority: LOG_ERR.
iface line speed: modem_line_speed
Reports the actual line speed that the two modems have negotiated between themselves. The modem
line speed is different than the serial port speed, as set by the ifconfig modemX speed command. Certain
uncontrollable telephone conditions can cause the modem_line_speed to be lower than expected, and may
also cause the modem line speed message to be absent. The modem line speed message will reappear with
normal telephone line conditions. Priority: LOG_INFO.
iface link idle, hanging up
No data has been transmitted over the modem link for the specified idle timeout and the Router is
dropping the telephone line, as the normal response. Priority: LOG_INFO.
iface link lost, going idle
The Router has sensed a lost carrier signal for reasons unrelated to the local modem. This usually