Black Box LRA005A-R2 - Manual (Page 213)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
213
4. TCP/IP-only Commands
The Router is always in one of two modes. The prompt always indicates the current mode:
• (ipx)Router> Router is in IPX mode
• (tcp/ip)Router> Router is in TCP/IP mode
The commands in this chapter are for TCP/IP mode only for TCP/IP network environments.
Commands which work the same way in both IPX and TCP/IP environments are documented in
Chapter 2. Commands for IPX mode only are documented in Chapter 3. Several commands operate in
both IPX and TCP/IP modes with parameters that vary per mode. These commands are documented
with their appropriate parameters in both chapters.
From TCP/IP mode, either use the ipx command to enter IPX mode or use the prefix “ipx” with the
command.
TCP/IP-only commands are organized in this chapter alphabetically:
• arp—display or change ARP protocol parameters
• domain—configure for Internet domain name service (DNS)
• filter—configure/display TCP/IP filter information
• icmp—display ICMP protocol status
• ifconfig—display or change TCP/IP network parameters
• ip—display or change TCP/IP protocol parameters
• ipx—change to IPX mode
• netstat—display TCP/IP network statistics
• ping—send an ICMP packet to remote host
• rip—display or change RIP protocol parameters
• route—display or change TCP/IP routing table
• snmp—display or change SNMP protocol parameters
• syslog—display or configure system log
• tcp—display or configure TCP protocol parameters
• traceroute—trace the route to a host
• udp—display UDP protocol status