Black Box LRA005A-R2 - Manual (Page 180)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
180
ppp i&g_iface ipxcp {local | remote} node
[on | off | allow [on | off]]
IPX node number—Displays or sets whether the local or remote IPX node number is announced to the
other side or not. Also sets whether to allow a local or remote node number from the remote side.
ppp i&g_iface ipxcp {local | remote} default
ipxcp configuration settings—Change the selected interface’s ipxcp configuration settings back to their
defaults. Defaults are provided for each subcommand.
2.18.6 A UTHENTICATION OF U SERS
ppp i&g_iface chap user username [password]
ppp i&g_iface pap user username [password]
Displays or sets username to be sent when the peer requests that your Router to authenticate itself. The
password to be sent may be set, but not displayed. When the username is specified, but no password is
supplied, the passwd file is searched for the password. This command overrides the default name which is
the system name, and the default password, which is the link password set in the config session. The
username and password may be different for the CHAP and PAP authentication protocols.
username Set the username. Default is the system name.
password Set the password. Default is the link password set in the config session.
Examples
ppp commands are not required for typical use of the Router. The most common use of the ppp
commands is to turn off the CHAP authentication protocol. Other commands require a more detailed
knowledge of the PPP protocol and are not recommended for use without such knowledge. For
example:
ppp modem0 lcp local auth none
This command sets the authentication type to none. The other choices are pap and chap.
Users often set the authentication type to none to examine the WAN link and then turn authentication
back on (chap or pap) once they are satisfied that the link is functioning properly.
The following commands are often used to connect to an Ascend router’s modem. Check the
parameters set on the Ascend router before using these commands. Note that the commands listed
below must be issued on both sides of the connection for proper configuration:
ppp modem0 lcp local accm 0xa0000
ppp modem0 lcp local acfc off
ppp modem0 lcp local pfc off
ppp modem0 pap user user_acct pwd