Black Box LRA005A-R2 - Manual (Page 238)

ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
238
• RIP
• SNMP
• SYSTEM
• TCP
• TIP
• TRACE
• TRACEROUTE
A.1 Syslog Messages
This section contains a listing of error messages that the Router collects for the UNIX system logging
system (syslog).
syslog can be configured to send messages to a specified remote IP host (where they are displayed or
logged remotely, according to how the remote syslog daemon is configured), or to the Router’s serial
port console (after the syslog on command has been entered at the console).
The system messages are listed in alphabetical order within defined categories (groups), as they are
displayed on the screen. The groups identify the source module from which the error message
originated. The priority entries (assigned by syslog) indicate which log in syslog that the message is stored
in. Also refer to the syslog command.
A.1.1 CHAP GROUP
iface CHAP failed to verify user_name
The system at the other end of the PPP link presented an invalid username; the Router will disconnect
the line. Reconfigure CHAP with the correct user and password information. Priority: LOG_ERR
iface CHAP Unexpected remote challenge
The remote system has requested CHAP password validation, but this end does not have a userid or
password configured. Use the config modify command to add the CHAP user name. Reboot the local
Router to effect the configuration. When this error occurs, link validation is declared failed and the link
is disconnected. Priority LOG_ERR.
iface CHAP peer says: salutation_string
The information string returned by a peer CHAP authenticator. This string could say Welcome on a
successful connection, or Invalid response on an unsuccessful connection attempt. This message can help
you determine if the link was established successfully. Priority: LOG_INFO.
A.1.2 D IALER G ROUP
Account disabled at this time
The client (who is logged in) is being disconnected because their access shift has just expired. Priority:
LOG_WARNING.
iface call failed: reason
The Router has attempted to place a call and failed to connect. Any of the following reasons for failure
may be displayed: NO CARRIER, BUSY, NO DIALTONE, NO ANSWER. Priority: LOG_ERR.