Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1153)

Brocade 6910 Ethernet Access Switch Configuration Guide 1103
53-1002581-01
Multicast VLAN Registration for IPv6
46
Command Usage
• Multicast groups can be statically assigned to a receiver port using this configuration page.
• All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One double colon may be used in the address to
indicate the appropriate number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
• The MVR6 VLAN cannot be specified as the receiver VLAN for static bindings.
Parameters
These parameters are displayed:
• Domain ID – An independent multicast domain. (Range: 1-5)
• Interface – Port or trunk identifier.
• VLAN – VLAN identifier. (Range: 1-4093)
• Group IPv6 Address – Defines a multicast service sent to the selected port. Multicast groups
must be assigned from the MVR6 group range configured on the Configure General page.
Interface
To assign a static MVR6 group to an interface:
1. Click Multicast, MVR6.
2. Select Configure Static Group Member from the Step list.
3. Select Add from the Action list.
4. Select an MVR6 domain.
5. Select a VLAN and interface to receive the multicast stream, and then enter the multicast
group address.
6. Click Apply.
FIGURE 393 Assigning Static MVR6 Groups to a Port
To show the static MVR6 groups assigned to an interface:
1. Click Multicast, MVR6.
2. Select Configure Static Group Member from the Step list.
3. Select Show from the Action list.