Show management – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual

Page 240

Advertising
background image

190

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Management IP Filter

9

Command Usage

If anyone tries to access a management interface on the switch from an invalid address, the
switch will reject the connection, enter an event message in the system log, and send a trap
message to the trap manager.

IP address can be configured for SNMP, web, and Telnet access respectively. Each of these
groups can include up to five different sets of addresses, either individual addresses or
address ranges.

When entering addresses for the same group (i.e., SNMP, web, or Telnet), the switch will not
accept overlapping address ranges. When entering addresses for different groups, the switch
will accept overlapping address ranges.

You cannot delete an individual address from a specified range. You must delete the entire
range, and reenter the addresses.

You can delete an address range just by specifying the start address, or by specifying both the
start address and end address.

Example

This example restricts management access to the indicated addresses.

Console(config)#management all-client 192.168.1.19

Console(config)#management all-client 192.168.1.25 192.168.1.30

Console#

show management

This command displays the client IP addresses that are allowed management access to the switch
through various protocols.

Syntax

show management {all-client | http-client | snmp-client | telnet-client}

all-client - Displays IP addresses for all groups.

http-client - Displays IP addresses for the web group.

snmp-client - Displays IP addresses for the SNMP group.

telnet-client - Displays IP addresses for the Telnet group.

Command Mode

Privileged Exec

Example

Console#show management all-client

Management Ip Filter

HTTP-Client:

Start IP address End IP address

-----------------------------------------------

1. 192.168.1.19 192.168.1.19

2. 192.168.1.25 192.168.1.30

SNMP-Client:

Start IP address End IP address

-----------------------------------------------

1. 192.168.1.19 192.168.1.19

Advertising