Displaying dhcp snooping binding information – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 958
908
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
DHCP Snooping
41
Displaying DHCP Snooping Binding Information
Use the IP Service > DHCP > Snooping (Show Information) page to display entries in the binding
table.
CLI References
•
“show ip dhcp snooping binding”
Parameters
These parameters are displayed:
•
MAC Address – Physical address associated with the entry.
•
IP Address – IP address corresponding to the client.
•
Lease Time – The time for which this IP address is leased to the client.
•
Type – Entry types include:
•
DHCP-Snooping – Dynamically snooped.
•
Static-DHCPSNP – Statically configured.
•
VLAN – VLAN to which this entry is bound.
•
Interface – Port or trunk to which this entry is bound.
•
Store – Writes all dynamically learned snooping entries to flash memory. This function can be
used to store the currently learned dynamic DHCP snooping entries to flash memory. These
entries will be restored to the snooping table when the switch is reset. However, note that the
lease time shown for a dynamic entry that has been restored from flash memory will no longer
be valid.
•
Clear – Removes all dynamically learned snooping entries from flash memory.
Interface
To display the binding table for DHCP Snooping:
1. Click IP Service, DHCP, Snooping.
2. Select Show Information from the Step list.
3. Use the Store or Clear function if required.