Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 188)

138 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Flow Sampling Commands
8
Example
This example set the owner’s name to Lamar.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow owner Lamer
Console(config-if)#
sflow polling-interval
This command configures the interval at which counters are added to the sample datagram. Use
the no form to restore the default polling interval.
Syntax
sflow polling-interval seconds
no sflow polling-interval
seconds - The interval at which the sFlow process adds counter values to the sample
datagram. (Range: 0-10000000 seconds, where 0 disables this feature)
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
This example sets the polling interval to 10 seconds.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow polling-interval 10
Console(config-if)#
sflow sample
This command configures the packet sampling rate. Use the no form to restore the default rate.
Syntax
sflow sample rate
no sflow sample
rate - The packet sampling rate, or the number of packets out of which one sample will be
taken. (Range: 256-16777215 packets)
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)