Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 600)

550 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
CFM Commands
25
Default Setting
Disabled
Command Mode
Privileged Exec
Command Usage
• Before using this command to start the cross-check process, first configure the remote MEPs
that exist on other devices inside the maintenance association using the
mep crosscheck mpid
command. These remote MEPs are used in the cross-check operation to verify that all
endpoints in the specified MA are operational.
• The cross-check process is disabled by default, and must be manually started using this
command with the enable keyword.
Example
This example enables cross-checking within the specified maintenance association.
Console#ethernet cfm mep crosscheck enable md voip ma rd
Console#
show ethernet cfm maintenance-points remote crosscheck
This command displays information about remote MEPs statically configured in a cross-check list.
Syntax
show ethernet cfm maintenance-points remote crosscheck
[domain domain-name | mpid mpid]
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows all remote MEPs statically configured on this device.
Console#show ethernet cfm maintenance-points remote crosscheck
MPID MA Name Level VLAN MEP Up Remote MAC
---- -------------------- ----- ---- ------ ------------------
2 downtown 4 2 Yes 00-0D-54-FC-A2-73
Console#