JLG G5-18A Service Manual - Manual (Page 54)

Cab
4-6 G5-18A, 2505H, 25.5
4.4.4 Accelerator Pedal Replacement
a. Accelerator Pedal Removal
1. Park machine on a hard, level surface.
2. Fully retract boom, lower boom, place transmission
control lever in (N) NEUTRAL.
3. Engage park brake and shut engine OFF.
4. Place a Do Not Operate Tag on both ignition key
switch and steering wheel.
5. Properly disconnect battery.
6. Open engine cover. Allow system fluids to cool.
7. Remove hardware (12) securing pedal assembly to
cab frame.
8. Disconnect sensor (13) from pedal assembly.
9. Remove accelerator pedal assembly from cab.
b. Accelerator Pedal Installation
1. Reconnect sensor (13) to pedal assembly.
2. Align pedal assembly with its mount holes under
cab dash.
3. Install hardware (12) securing pedal assembly
to mount.
4. Properly connect the battery.
5. Close and secure engine cover.
6. Remove a Do Not Operate Tag on both ignition key
switch and steering wheel.
MY8870
12
12
13