AirLive WLA-9000AP - Manual (Page 63)

4. Web Management: Wireless and WAN Settings
AirLive WLA-9000AP User’s Manual 56
4.2.12 Enable Wireless Client Isolation
Select the check box to prohibit data transmission between client stations. This function is
also known as “Privacy Separator”.
4.2.13 Bandwidth Control
Operation Mode -> Setup -> Bandwidth Control
Bandwidth Control can limit the maximum speed of entire wireless interface or individual
device. It is also known as Traffic Shaping. The WLA-9000AP provides both Total
Bandwidth and Per-User Bandwidth Control for both uplink and downlink speed. It
controls the speed of both wireless and wired interface.
To configure, please click on the “Bandwidth Control” button under wireless settings. The
following screen will appear:
„ Enable Bandwidth: Check to enable Bandwidth Control. Uncheck to disable it.
The default value is disabled.
You must select between Total Bandwidth and Per-User Bandwidth. They can not be
enabled at the same time.
After enabling
Bandwidth
Control and
selecting “Total”
or “Per User”
type, click here
to Apply
Check to
enable
Bandwidth
Control
Select Total
or Per User
control here
Settings for Total
Bandwidth Control
Settings for Per-User
Bandwidth Control