AirLive WLA-9000AP - Manual (Page 68)

4. Web Management: Wireless and WAN Settings
61 AirLive WLA-9000AP User’s Manual
Access Point mode included in these operation modes: Dual AP, AP + Client, Client + AP,
AP + WDS Bridge, WDS Bridge + AP, AP + Gateway, Gateway + AP, AP + WISP and WISP
+ AP modes.
Enable Radio
: Use this check box to turn on or
turn off the radio.
¾
Network ID (SSID): This is to change your
SSID.
¾ Disable SSID Broadcasting: Enable the
check box if you want to hide your SSID in
the network. This prevent an un-welcomed
client survey your radio.
¾ Mode: Connection modes on
WLA-9000AP and its wireless client. Note
that the client must support the same
mode as WLA-9000AP to connect.
¾ Channel: 11a supports channel 36 to 64
and channel 100 to 140. 11g depends on
the country, USA/Canada supports
channel 1 to 11, Europe supports channel
1 to 13, Japan supports channel 1 to 13,
France supports channel 10 to 13, and
Span supports channel 10 to 11.
¾ Enable Radio eXtended Range: Check this box to extend the wireless coverage
range, this is provided by Atheros’s eXtended Range (XR) technology.
¾ Enable Client Isolation (Privacy Separator): This is to prohibit data transmission
between each wireless client stations.
¾ Enable 802.11d: This is to prevent network loop applying to the spanning tree
standard.
4.4 WDS Settings
Operation Mode -> Setup -> WDS Settings
In this mode, 2 access points in two remote locations connect to each other to provide a
wireless bridge between 2 remote LANs. It is mostly used by enterprise to connect 2 remote
office’s network together. The bridge modes are connected by using the WDS (Wireless
Distribution System) technology.