Chapter 5: unpacking the drive components, Chapter 5, Unpacking the drive components – ElmoMC Gold Line Digital Servo Drives-Gold Drum Ver 1_400 D-Sub connectors User Manual
Page 10
Gold Drum (D-Sub Connectors) Installation Guide
MAN-G-DRUM(DTYPE)IG-EC (Ver. 1.400)
|Technical Data
10
Chapter 5:
Unpacking the Drive Components
Before you begin working with the Gold Drum, verify that you have all of its components, as
follows:
•
The Gold Drum servo drive
•
The Elmo Application Studio (EASII) software and software manual
The Gold Drum is shipped in a cardboard box with Styrofoam protection.
To unpack the Gold Drum:
1.
Carefully remove the servo drive from the box and the Styrofoam.
2.
Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3.
To ensure that the Gold Drum you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Gold Drum. It looks like this:
4.
Verify that the Gold Drum type is the one that you ordered, and ensure that the voltage
meets your specific requirements.
The part number at the top provides the type designation. Refer to the appropriate part
number in the section Catalog Number at the beginning of the installation guide.