ElmoMC SimplIQ Digital Servo Drives-Trombone DC - Manual (Page 19)

DC Trombone Installation Guide Installation
MAN-DCTROIG (Ver. 1.601)
www.elmomc.com
19
3.2. Unpacking the Drive Components
Before you begin working with the DC Trombone system, verify that you have all of its
components, as follows:
• The DC Trombone servo drive
• The Composer software and software manual
The DC Trombone is shipped in a cardboard box with Styrofoam protection.
To unpack the DC Trombone:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the DC Trombone you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the DC Trombone. It looks like
this:
The P/N number at the top gives the type designation as follows:
4. Verify that the DC Trombone type is the one that you ordered, and ensure that the voltage
meets your specific requirements.