ElmoMC SimplIQ Digital Servo Drives-Trombone DC - Manual (Page 65)

DC Trombone Installation Guide Installation
MAN-DCTROIG (Ver. 1.601)
www.elmomc.com
65
3.10. Powering Up
After the DC Trombone has been mounted, check that the cables are intact.
The DC Trombone servo drive is then ready to be powered up.
Caution:
Before applying power, ensure that the DC supply is within the range specified
for your specific type of DC Trombone and that the proper
plus-minus connections are in order.
3.11. Initializing the System
After the DC Trombone has been connected and mounted, the system must be set up and
initialized. This is accomplished using the Composer, Elmo’s Windows-based software
application. Install the application and then perform setup and initialization according to the
directions in the Composer Software Manual.