Lenze E94AxHE Technology Application Positioning sequence control - Manual (Page 18)

9400 Technology applications | Positioning sequence control
Short setup
Step 2: Parameterising the application
18
L
EDS94TA10060xxxx EN 1.2 - 03/2010
Setting the machine parameters
1. Set the selection "mm" as unit (C02525).
– This parameter is used to define the real unit of the machine for the selection of
physical values (e. g. speeds, accelerations and decelerations).
2. Set feed constant (C02524).
– The feed constant corresponds to the motion of the machine at one revolution of the
gearbox output shaft.
– For the sheet stacker: Feed constant = 250 mm/rev.
3. Click Back to go back to the Overview dialog level.
4. In the Overview dialog level, click Program flow to change to the dialog level Overview
 Program flow and select the positioning program.
Go to dialog: Overview
Machine parameter