Lenze E94AxHE Technology Application Positioning sequence control - Manual (Page 24)

9400 Technology applications | Positioning sequence control
Short setup
Step 3: Parameterising the program flow
24
L
EDS94TA10060xxxx EN 1.2 - 03/2010
4.6.7 Program step 7: Resetting the status output
4.6.8 Program step 8: Going back to program step 2
Action Comment Parameter Setting
Reset sequence control output 1 to "0", when start
position is reached.
Selection Action Number: 2
Output for A switching: Output 1
Signal state for A switching:
Output for B switching: Deactivated
Signal state for B switching:
Action Comment Parameter Setting
Go back to program step 2. Selection Action Number: 1
Jump input: Continue
with next
step
Jump destination: 2
0
1