MacDon Transport D60 - Manual (Page 14)

ELECTRICAL
Form 147398 12 Revision J
STEP 3. INSTALL HEADER
ELECTRICAL HARNESS
There are three different factory installed wiring
harness configurations and each requires a
slightly different installation procedure. The
harness is located at the left leg.
INSTALLATION A – use this procedure for a 2007
header with a 4-pin flat connector on the wiring
harness.
INSTALLATION B – use this procedure for a 2008
header with a modified harness equipped with a 4-
pin flat connector and a 6-pin square connector.
INSTALLATION C – use this procedure for a 2008
or newer header with a 6-pin square connector.
INSTALLATION A
2007 Header with a 4-Pin Flat Connector
Requires installation of wiring harness #193061
which is included in shipping bundle B4925.
a. Remove end shields from both ends of header.
b. At the header left transport leg, remove the two
clamps (A) and retain for reinstallation.
c. Remove cap on connector (B) existing wiring
harness (C).
d. Attach new harness (D) to existing harness (C)
with connector (E).
e. On Double Knife headers, a fish tape or equivalent
must be used. Insert fish tape into right end of
backtube and route tape through backtube until it
reaches grommet hole at left transport leg.
f. On Single Knife headers, insert a fish tape as
described above. If you do not have a fish tape,
the following procedure can be used:
(continued next page)
C
D
E
A
A
B
B
C
B