MacDon Transport D60 - Manual (Page 21)

SUSPENSION
Form 147398 19 Revision J
STEP 5. INSTALL REAR
SUSPENSION
a. Loosely install four 3/8 NC X 0.75 LG carriage
bolts (A) at the base of the vertical leg. Install
bolts from inside leg.
b. Lift axle (B) and channel/spring subassembly (C),
and position lower end of subassembly (C) into
leg.
c. Position lower end of subassembly (C) on bolts
(A)
d. Slide subassembly (C) into leg.
e. Attach top of subassembly (C) to leg with two
3/8 NC X 0.75 LG carriage bolts (D) and smooth
face lock nuts in right side of leg, and two
3/8 NC X 1.0 LG carriage bolts (E) and smooth
face lock nuts in left side of leg. Install bolts from
inside leg
f. Tighten all hardware except bolts (E).
g. Pull handle (F) to release the spring and position
linkage in 4
th
slot (G) from the top. Lower handle
to lock.
h. Remove L-pin (H) from leg storage location and
install in transport lock position.
i. The right-hand fixed axle is now in transport
position.
A
A
C
E D
B
F
G
H
H