MacDon Transport D60 - Manual (Page 19)

ELECTRICAL
Form 147398 17 Revision J
INSTALLATION C
2008 or Newer Header with 6-Pin Square
Connector.
a. Remove cap on connector (A) and cut plastic tie
(B).
b. Route the connector (C) and wiring harness (D)
under leg to the axle and through bracket (E).
c. Position clip (F) and connector (C) inside bracket
(E) and attach clip to bracket with two
¼ NC X 0.5 LG self-tapping screws (G).
d. Secure wiring harness to axle with holder (H) and
two 3/8 NC X 0.625 LG self-tapping screws (J). If
necessary, loosen clamp inside leg and adjust
harness length as required.
C
F
G
D
E
C
TIP
Install and remove self-tapping screws
before attaching holder.
O
P
C
A
B
D