MacDon Transport D60 - Manual (Page 46)

TOW-BAR
Form 147398 44 Revision J
STEP 18. DETACH AND STORE
TOW-BAR
a. Disconnect wiring connector (A) at front wheel.
b. Remove clevis pin (B)
.
c. Push latch (C) and lift tow-bar (D) from hook.
Release latch (C) and replace clevis pin (B).
d. Disconnect wiring connector (E) on tow-bar.
e. Remove pin (F) from tow-bar and lift forward
section (G) out of aft section (H) to disassemble.
f. Locate end of forward section (G) in bracket (J) on
left endsheet and install hitch pin (K). Secure with
lynch pin.
g. Position opposite end in cradle (L) and secure with
bungee (M).
h. Locate end of aft section (H) in bracket (N) on
right endsheet and install L-pin (F). Secure with
split ring (O) as shown.
i. Position opposite end in cradle (P) and secure
with bungee (Q).
A
D
C
B
E
F
G
H
G
J
K
L
M
H
N
F
O
Q
P