MacDon Transport D60 - Manual (Page 15)

ELECTRICAL
Form 147398 13 Revision J
1. Fully lower reel.
2. Disconnect one of the steel hydraulic lines at
each end of backtube and install plugs on
open lines.
3. Attach a piece of wire to hydraulic line at left
end and pull line through backtube until wire
(F) can be pulled through grommet hole at left
transport leg.
g. Attach the end (labelled “A”) of new harness (D) to
fish tape or wire (F) on hydraulic line with electrical
tape. If necessary, remove a portion of harness
covering so that harness wiring and covering can
be secured to fish tape or equivalent.
h. Feed the harness (D) into the backtube and pull
hydraulic line or fish tape through backtube until
harness (D) reaches right end.
i. Remove harness from fish tape or hydraulic line.
j. Feed harness (D) out grommet hole at right side of
backtube.
k. Push hydraulic line back through backtube,
remove plugs and re-connect hoses to line.
l. Locate the six pin weather pack connector (G)
near right endsheet.
m. Unclip and pull back the TPA (Terminal Position
Assurance) clip (H) on connector (G).
n. Remove green weather plug (J) (beside black wire
and marked “A” on connector) from connector and
insert new harness wire (D).
o. Reattach the TPA clip (H) on the connector.
p. Tape new harness (D) to existing harness at the
base of the connector (G).
(continued next page)
F
D
A
RIGHT SIDE
LEFT SIDE
D
G
H
J
D
A
A