MacDon Transport D60 - Manual (Page 33)

LIGHTS
Form 147398 31 Revision J
C. INSTALL SPLICE
The lighting harness at the endsheet transport
light needs to be modified to include a splice at the
6-pin flat connector. This modification is only
applicable to some Export kits that have a light
without a built in module. Refer to the electrical
schematic on page 34.
a. Locate the 6-pin flat connector (A) at the end of
the header portion of the electrical harness (B).
b. Unclip and pull back the TPA (Terminal Position
Assurance) clip (C) on connector (A).
c. Locate the wire (D) inside the conduit from pin
position “A” on connector.
d. Pull out a short length to accommodate the splice.
e. Obtain a length of wire (E) the same gauge as the
existing wires for the splice.
f. Attach a pin connector (F), similar to the one
shown to the splice (E).
g. Pull out the green weather plug (G) from position
“F” on connector (A).
h. Insert splice (E) at position “F”.
i.
Connect other end of splice to wire (D) from pin
position “A” with a T-type connector, or by
soldering the splice to the existing wire.
j. Insert the connection into the conduit and wrap the
conduit with electrical tape.
k. Reattach the TPA clip (C) on the connector.
B
A
A
C
F
E
F F
G
D
F
A
E
F
A
CONNECTOR SHOWN WITH CAP REMOVED