MacDon Transport D60 - Manual (Page 32)

LIGHTS
Form 147398 30 Revision J
g. Connect harness (C) to light at connector (D).
h. Secure harness (C) at end of arm with clip (E) that
was removed from endsheet and a
3/8 NC X 1.0 LG carriage bolt (F) and nut.
i. Secure harness inside arm with two additional
clamps (G) and 3/8 NC X 0.75 LG carriage bolts
(H) and nuts.
j. Route harness (C) over lift cylinder and secure to
cylinder fitting with plastic tie (J) as shown.
k. Reposition cylinder back into reel arm bracket and
re-install clevis pin (A). Secure with cotter pin,
being careful not to pinch harness (C).
l. Secure harness to inside of reel arm bracket using
another cable tie as shown.
H
G
C
E
F A
C
J
C
D
C