MacDon Transport D60 - Manual (Page 28)

LIGHTS
Form 147398 26 Revision J
F
E
STEP 11. INSTALL LIGHTS
A. ATTACH LIGHTS
I. ENDSHIELD LIGHT
a. Remove end shield.
b. Remove divider rods (A) (if installed) from storage
location.
c. Remove bolts (B) and remove and bracket (C) on
endsheet. Retain hardware.
d. Remove clip (D) that attaches wiring harness to
endsheet. Retain for re-installation on reel arm.
e. Retrieve light assembly from transport kit.
f. Remove screws (E) and remove cover (F) from
light assembly.
g. Reinstall bracket (C) on light cover (F) with
existing hardware (B).
h. Position light (G) on endsheet picking up existing
holes, and install three 3/8 NC X 0.75 LG carriage
bolts (H) and nuts.
i. Do not re-install cover (F) at this time.
SHOWN WITH MODULE
G
K
H
B
C
D
A
E
F
B