Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 15)

Product Reference Guide 5
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged. If
any damage occurred during shipment, contact Wasp Barcode Technologies Technical Support.
Information is shown on
page 2 .
KEEP THE PACKAGING. Should the unit ever require service, it should be returned in its
original shipping container.
Setting Up the Reader
F ollow the steps provided in this section to connect and get your reader up and communicating
with its host.
1. Begin by Installing the Interface Cable.
2. Go to Interface Selection and set the desired interface.
3. Configure Interface Settings (only if not using factory settings for that interface)
4. Go to Configuring Other Features (if modifications are needed from factory settings)