Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 47)

Keyboard Settings Enter/Exit Programming Mode
Product Reference Guide 37
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks keyboard
connection in order to transmit data to host. The selectable range for this setting is 00 to 990
milliseconds (00-0x63 by 01) in increments of ten milliseconds.
See page 214 in “References”
for detailed information and examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT 0A = Quiet Interval is
100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds. See
page 216 in “References” for detailed information
and examples for setting this feature.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT 00 = No Wedge Intercode Delay