Rockwell Automation 160 AC DRIVE SER B/FRN 5-6.XX - Manual (Page 12)

Chapter 1
Information and Precautions
1-1
General Information 1
Receiving – It is your responsibility to
thoroughly inspect the equipment before
accepting the shipment from the freight company.
Check the item(s) received against the purchase
order. If any items are obviously damaged, do not
accept delivery until the freight agent notes the
damage on the freight bill.
If you find any concealed damage during
unpacking notify the freight agent. Also, leave the
shipping container intact and have the freight
agent make a visual inspection of the equipment
in order to verify damage.
Unpacking – Remove all packing material,
wedges, or braces from within and around the
controller. Remove all packing material from the
heat sink.
Inspection – After unpacking, check the item(s)
nameplate catalog number against the purchase
order. An explanation of the catalog numbering
system for the Bulletin 160 controller is included
as an aid for nameplate interpretation. Refer to
the following page for complete nomenclature.
Important: Before you install and start up the
controller, inspect the mechanical integrity of the
system (e.g., look for loose parts, wires,
connections, etc.).
General Precautions
In addition to the precautions listed throughout
this manual, you must read and understand the
following statements which are general to the
system.
ATTENTION: This controller
contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static
control precautions are required when
installing, testing, servicing or
repairing this assembly. Component
damage may result if ESD control
procedures are not followed. If you are
not familiar with static control
procedures, reference A-B Publication
8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other
applicable ESD protection handbook.
ATTENTION: Only personnel
familiar with the controller and
associated machinery should plan or
implement the installation, start-up,
and subsequent maintenance of the
system. Failure to comply may result
in personal injury and/or equipment
damage.
ATTENTION: The surface
temperatures of the controller may
become hot, which may cause injury.
ATTENTION: An incorrectly
applied or installed controller can
result in component damage or
reduction in product life. Wiring or
application errors such as undersizing
the motor, supplying an incorrect or
an inadequate AC supply, or
excessive ambient temperatures may
result in system malfunction.
ATTENTION: The controller
contains high voltage capacitors
which take time to discharge after
removal of mains supply. Before
working on controller, ensure
isolation of mains supply from line
inputs [L1, L2, L3 (U, V, W)]. Wait
one minute for capacitors to
discharge to safe voltage levels.
Failure to do so may result in
personal injury or death.
SSC is a trademark of Rockwell Automation