Rockwell Automation 160 AC DRIVE SER B/FRN 5-6.XX - Manual (Page 45)

Appendix A – Specifications and Accessories
A-2
Table A.3 – Specifications For All Controller Ratings
Input/Output Ratings (All Controller Ratings)
Output Voltage (V) Adjustable from 0V to input voltage
Output Frequency (Hz) 0 to 240 Hertz Programmable
Efficiency (%) 97.5% (Typical)
Transient Protection Standard 2 kV (Optional 6 kV using MOV module). See accessories on page A-5.
Environmental Specifications (All Controller Ratings)
Enclosure IP 20
Ambient Temperature 0 _C to 50_C
Storage Temperature –40 _C to 85_C
Relative Humidity 0 to 95% (non condensing)
Vibration 1.0 G Operational – 2.5 G Non-operational
Shock 15 G Operational – 30 G Non-operational
Altitude 1,000 m (3,300 ft.) without derating
Control Inputs (All Controller Ratings)
Control Input Type For dry contact closure input – the controller has an internal 12V power supply that provides
10mA (typical) current flow.
Also accepts open collector/solid state inputs (sinking) with maximum leakage current of 50 mA.
Optional 24V DC interface allows use of 24V DC sinking inputs.
See page A-4 for ordering information.
Start, Stop, Forward/Reverse Configurable inputs for 2 or 3 wire control
SW1, SW2, SW3
(Preset Speed Model only)
Configurable Inputs for control of 8 preset speeds and 2 Accel/Decel times
Programmable Input TB3-8 can be configured to select:
Accel/Decel Times
Controller Enable/Disable
Local/Remote
Approvals and Standards Compliance (All Controller Ratings)
Approvals
ОО
ОО
ОО
UL508C CSA 22.2
ОО
ОО
ОО
ОО
ОО
ОО
ОО
ОО
ОО
ОО Designed to meet these standards IEC 146–1–1
FCC Class A
➀
and B
➀
VDE 0871
➀
and 0875
➀
Control Inputs (Analog Signal Follower only – All Controller Ratings)
External Speed Potentiometer 1K to 10K Ohms, 2 Watts Minimum
Analog Input (4 to 20mA) Input lmpedance 250 Ohms
Analog Input (–10 to +10V DC) Input Impedance 100K Ohms
Control Output (All Controller Ratings)
Programmable Output
(Form C Relay contact) Resistive rating: 0.4A @125V AC, 0.2A @ 230V AC, 2A @ 30V DC
Inductive rating: 0.2A @ 125V AC, 0.1A @ 230V AC, 1A @30V DC
➀ With external components.