Rockwell Automation 1336T Function Block Prog. Manual, Series A/B - Manual (Page 10)

Preface P–4
1336 FORCE – 5.9 August 1995
Developing and successfully entering a new function block
application in your 1336 FORCE involves four distinct steps. These
steps are shown below and on the following pages of this chapter
using DriveTools.
Step 1 — Create an Execution List.
You can create an execution list by entering function blocks into an
on screen display. The execution list entries are shown on the left
side of the DriveBlockEditor screen shown below.
Execution
List
Sequence ID # Type
These events or function blocks (Limit, Set Reset FF, Multiplexer,
etc.) are chosen from the function block library. You may enter any
combination of events up to a total of 128 in your execution list.
Events are executed in the order in which you enter them in the list.
A full description of each available function block can be found in
Chapter 4 .
Step 2 — Enter Block Values
Once you have entered all events into your execution list, you may
want to adjust the values of the node parameters of the function
blocks. These values are entered in the Value column on the right
side of the DriveBlockEditor screen as shown on the next page.
Node values must be within the range specified by the maximum and
minimum limits.
Chapter 2 provides detailed examples on entering
function block nodes.
Function Block
Components