Rockwell Automation 1769-SDN Compact I/O DeviceNet Scanner Module User Manual User Manual
Page 21
Publication 1769-UM009E-EN-P - August 2009
21
Quick Start for Experienced Users Chapter 2
3.
Assemble and mount the I/O bank.
The scanner module can be attached to an adjacent controller, power
supply, or I/O module. The scanner module can be panel or DIN-rail
mounted. Modules can be assembled before or after mounting.
Be sure to observe minimum spacing guidelines for adequate
ventilation.
4.
Ground the scanner module and complete the DeviceNet network
wiring.
5.
Apply power to the system.
6.
Be sure that the programming software and equipment is ready.
7.
Use RSLinx to configure drivers.
8.
Use RSNetWorx for DeviceNet software to configure the 1769-SDN
scanner module and the DeviceNet devices.
9.
Use RSLogix software to create your project and ladder logic.
10.
Start the system.
a. Apply power.
b. Download your program and put the controller into Run mode.
c. status indicators turn on solid green.
11.
Monitor the scanner module status to check if the scanner module is
operating correctly.
Module status is reported by the status indicators and numeric display
on the front of the scanner module. The information is also stored in
the scanner module’s input data file, so these bits can be used in your
control program to flag an error.