Put the scanner in run mode – Rockwell Automation 1769-SDN Compact I/O DeviceNet Scanner Module User Manual User Manual
Page 60
Advertising
60
Publication 1769-UM009E-EN-P - August 2009
Chapter 4 Automatically Configure a DeviceNet Network
Put the Scanner in
Run Mode
Follow these steps to run the DeviceNet network.
1.
Place the controller in Run/Remote Run mode.
2.
Set the following bit of the output structure for the scanner.
3.
Check to see if the scanner is in Run mode, by making sure an 80 status
code does not appear on the scanner’s display.
If you want to
Set this bit
To:
run the network
…O.CommandRegister.Run
1
not run the network (idle mode)
…O.CommandRegister.Run
0
Advertising