Brandmotion 2000-3811 - Manual (Page 17)

Section 6: Toyota Avalon, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 17 of 54
22. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the 4-
pin connector from the DPS module and wait another
10 seconds.
23. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should now
be sound from the speakers). Ensure radio head unit
is working properly including all speaker channels.
24. Turn ignition key to “LOCK” (OFF) and remove key.
25. Secure DPS module using supplied 24” Wire Ties.
26. Re-install removed parts in reverse order of removal.
27. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.