Brandmotion 2000-3811 - Manual (Page 20)

Section 7: Toyota Camry, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 20 of 54
15. Pull out radio/climate control assembly slowly and
carefully. Detach wire harness from back of
assembly.
16. Place DPS module in front console cavity as shown.
Do not secure with supplied 24” wire ties at this
time.
17. Route the DPS harness along the factory harness
and up to the radio area. Use supplied wire ties to
secure DPS harness away from any moving parts.
18. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
19. Reinstall radio.
20. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
21. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
22. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
23. Unplug the small 4-pin connector from DPS module.