Brandmotion 2000-3811 - Manual (Page 26)

Section 9: Toyota FJ Cruiser, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 26 of 54
1. Ensure all radio functions are working properly, return
all Treble, Bass, Fade, and Balance to neutral settings,
and remove any CDs to avoid possible jam before
disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set parking
brake.
3. Loosen negative battery cable bolt using a 10mm
socket. Remove negative battery cable from terminal
and position away from battery.
4. Disengage the 3 clips and remove the instrument
panel garnish.
IMPORTANT: Pull the instrument panel garnish up at an
angle of 45° to remove it. Do not damage the surface of
the instrument panel when removing it.
5. Disengage the 4 clips and remove the integration
control panel assembly. Disconnect the 3 connectors.
6. Remove the 4 bolts and the radio receiver. Disconnect
the plug, the head unit connector and the 2 radio
connectors.
7. Disengage the 2 “A” claws and 2 “B” claws retaining
the parking brake opening cover. Slide the cover
toward the front of the vehicle, disengage the 2 “C”
claws and remove the parking brake opening cover.
8. Disengage the 5 clips and 3 claws retaining the
console upper rear panel and remove the panel.
9. Locate an area under the console to which to mount
the DPS module. Do not mount in an area with moving
parts or sharp edges that could cut or damage the
wire harness. Do not secure the DPS module with the
supplied 24” wire ties until later.
10. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
11. Reinstall radio.